Sanitary Fittings - Clamp Gaskets

Product Introduction

Clamps use high-quality stainless steel materials, using different modeling structures and manufacturing processes to meet the needs of different types of hose connection hoop. Clamp has a beautiful shape, easy to use, tight hoop strong, good sealing performance characteristics. Mainly used for vehicles, ships, diesel engines, gasoline engines, machine tools, fire, and other mechanical equipment, chemical equipment, ordinary hose, nylon plastic hose, cloth hose, water and other interfaces at the connection fastening and sealing.

product manual

Clamp has become the current liquid, gas pipeline connection of the devaluation technology, although the technology in the domestic development time later than abroad, but because of its advanced technology, and soon received by the domestic market. From 1998 to the beginning of research and development to now, after just a few years of development and application, has gradually replaced the flange and welding of the two traditional pipeline connection. Not only technically more mature, the market is generally recognized, but also by the national laws and regulations of the positive guide.

Product works:

1. Cut the pipe with the length of the pipe by the pipe cutting machine, check the cut section with the level to ensure that the cut section is perpendicular to the axis of the pipe. Cut if there is a burr, apply a grinder to smooth the grinding machine.

2. Clamps will need to process the groove of the steel pipe set in the roll slot machine and rolling hopper tailstock, flattened with the level, so that the steel pipe in a horizontal position. The

3. Clamps The pipe ends are in close contact with the grooving machine so that the axis of the pipe is perpendicular to the roller surface. The

4. slowly press down. Jack, so that the pressure roller close to the steel pipe, roll groove machine, so that the wheel rotation of a week, then pay attention to observe whether the steel pipe section is still tight with the rolling machine, if not close, should adjust the pipe to the level. If it is close, slowly depress the jack, so that the pressure roller evenly rolled steel pipe to the depth of the scheduled groove so far. The

5. When the clamp is stopped, check the groove depth and width with the vernier caliper. After confirming compliance with the standard requirements, remove the jack and remove the steel pipe. In the application of the clamp, you must grasp the precautions, and should pay attention to maintenance after use, so that its life extension.